Find out how to stitch a medical face mask for healthcare facilities with a pocket and nose guard with this totally free simple pattern and video tutorial.

As of right now, the supply of surgical masks is at an important all-time low throughout the entire country. Now is a time where crafters can band together and make a big difference throughout this challenging time.

Please inspect with your local hospital on what their requirements and requirements might be if you are preparing to donate them.

While handmade material face masks are not an alternative for N95 masks, in times of emergency situation, the CDC might allow handcrafted material masks to be utilized when lacks take place.

You can learn more from the CDC here on the use of homemade masks HERE.

Wash between each usage. This mask can be utilized as is or fit over another medical mask if you have one.

If you wish to purchase the ad totally free PDF download version of this pattern you can do so in my Etsy shop HERE.

1 piece of 100% cotton fabric cut:

15 ″ X 9 ″ for adult size

14 ″ X 8 ″ for teen size

13 ″ X 7 ″ for child size

12 ″ X 6 ″ for toddler size

-2 flexible strips 1/8 ″, 1/4 ″ x 6.5″ females, 7″ men, 5″ child

— Iron

— Pipeline cleaner (5 ″ for grownups, 4 ″ for kid)

Guidelines:

Cut your material according to size:

15 ″ X 9 ″ for adult size

14 ″ X 8 ″ for teen size

13 ″ X 7 ″ for child size

12 ″ X 6 ″ for toddler size

Fold the sides in 1/4 ″ and fold over once again 1/4 ″. Sew the sides down.

With the incorrect side out, fold your fabric in half vertically. Stitch along the top 2 ″ in on either side, leaving a 3 ″ -4 ″ opening at the top.

Bring your stitched seam with opening to the middle of your mask. Iron down the middle to make it flat.

Now we’re going to sew down the sides. Put your flexible in each corner on the within with the flexible dealing with in. The picture below programs how the elastic must look beneath the top layer. You can pin your flexible to assist keep it in location as you sew the sides or it also assists to hand sew completions in location prior to you stitch down the sides to keep them in place. Continue to sew down the sides with about 1/4 ″ seam allowance.

Fold your mask inside out through your opening.

Put your pipeline cleaner inside the pocket up along the top of the joint and pin to protect.

Turn your mask over with the right side facing you (not the pocket side) and begin your pleats. Start about an inch from the leading and fold your pleats up about 1/4 ″. Pin your pleats in location. Make a total of 3 pleats. Thoroughly sew around the whole mask being mindful to pull the pins out as you go. Attach off. Put your mask on with the pipe cleaner side at your nose. Lower around the pipe cleaner to fit the leading to your face.

You’re done! Insert your filter and wash between uses.

Pin it for later!

This content was originally published here.

Leave a Reply