Make this face mask with a filter pocket pattern with a tiny bit of fabric, elastic and blue shop towels.  The pattern is quick and easy ideal for beginner sewers!

If you don’t need a filter pocket and would like to use a lining fabric try my DIY face mask pattern.

If you feel adding a filter inside your mask gives added benefit this is the simplest way to do it.  There is a lot of information on what type of filter to add inside.  I decided to use blue shop towels. The beauty of this pattern is you can slip in any filter material you like.

Face Mask with Filter Pocket Supplies

For each adult mask you will need the following,  (affiliate links to my favorite supplies)

How to Make a Face Mask with Filter Pocket

It is actually super easy to make a filter mask with this step by step guide.

Fold the fabric in half right sides together. Stitch across the top edge with 1/2 inch seam leaving a 3 inch opening in the middle.

Bring seam to center to make it easy to press the seam open. Press seam open.

Bring the seam to the top. Line the edge of the seam allowance with the top fold. The opening in the seam creates the pocket. Press.

Place elastic inside the tube of fabric.

It is very important that the elastic lay straight (perpendicular) along the fold on each side. I find it easiest to tuck it in there and clip with a wonder clip and remove clip just before sewing.

If you don’t get it lined up it will cause the elastic to catch at a funny angle when turned right side out. You can see my mistake below and it caused the mask to not fit properly.

Stitch along both ends with a 1/4 inch seam.

Turn right side out. Press.

It is not necessary, but you can topstitch along the bottom fold of the pocket opening.  This helps to keep the flap down when placing and removing the filter.  It is a bit tricky to make sure you only stitch the fold, not through any other part of the mask. It doesn’t have to go the whole length of the opening. The top of the fold will be held in place with the final topstitching all the way around the mask.

Make three pleats on each end. Pin. Just eyeball the placement. Make sure the pleats are facing down on the front side. My ends measure about 3 – 3 1/2 inches after pleating.

Stich all the way around the mask 1/4 inch from the edge.

Stitch again along each end over the pleats 1/8th inch from the edge.

Filter Mask

Of course, this mask works great without placing a filter inside, but here is how you add a filter.

Cut one sheet of blue shop towels into four pieces. Slip two pieces of towel inside the mask through the pocket opening.

Blue Shop Towels

Suay Sew Shop found the ideal material turned out to be stretchy blue shop towels made from a polyester hydro knit.

Inserting two of these towels into an ordinary cotton mask brought filtration up to 93% of particles as small as 0.3 microns, the smallest their machine could test. Meanwhile, the cotton masks filtered 60% of particles at best in their tests, Schempf said.

Polyester hydro knit towels are readily available at hardware and automotive stores. The two brands they tested were ToolBox’s shop towel and ZEP’s industrial blue towel. Interestingly, Scott’s pro shop towels, which are also made with a hydro knit fabric, didn’t work as well, Schempf said —– Business Insider

DIY Face Mask (No Filter)

If you are looking for more information on sewn face masks my first pattern has a few more details about making masks. I also share measurements for a child’s mask.

This content was originally published here.

Leave a Reply